![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Morgans" wrote in message
... Actually, that is not true. It really does work, and work quite well. Also, they are not filtering it out, but adding to the subject. It is still up to the reader that does not want to read the post to write a filtering rule based on the added MX or whatever. Well, good luck with that. I've yet to see any thread where there's been a significant "contribution" (such as it is) from him, and yet where I saw any need to continue reading the thread. I just junk the whole thread when he starts a thread down the toilet. Frankly, now that I've stopped trying to talk any sense into the guy, I've found his presence to be hardly disruptive at all. But, if you think you can get people to consistently change the subject just so you can exercise a filter, more power to you. Far be it from me to try to discourage anyone from following along. Pete |
#2
|
|||
|
|||
![]()
MX Z Z Z ZOOOOOOM
denny rotflmao |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
directional gyro inlet filter | dlevy | Owning | 2 | October 9th 06 03:00 PM |
Pirep: SacSkyRanch Oil Filter Can Cutter | Jim Burns | Owning | 3 | January 1st 06 06:57 AM |
Century IIIB Rate Filter Parts and Schematics | PilotMike2004 | Owning | 1 | January 10th 05 12:01 PM |
Filter element for Frantz filter | Philippe | Owning | 1 | April 20th 04 08:23 PM |
where exactly to put the noise filter | Dico Reyers | Owning | 25 | February 25th 04 03:21 AM |