|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 29th 06, 06:26 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Fiberglass revisited
Lou wrote: I came across some fiberglass at 1.6oz per yard. I bought a small sample to play with but it's an extremely fine weave. I've been using the 1.45 oz e-glass for a while now. Can anyone tell me if this is just as good, better or worse to use? Lou It's harder to wet out. Strength should be the same, or better. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 2nd 04 11:15 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
| Fiberglass Tip Tanks Question | Jay Honeck | Owning | 7 | September 26th 03 04:23 AM |
Hybrid Mode
