![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Sounds like a solution to a non-existent problem.
Rich "To save an ounce, lose a hamburger" S. That weight reduction program is well underway. Hamburgers are in, just no carbs.......and the weight savings is already many times greater than all of the carbon and Spectra combined will save. I agree there isn't much of a "problem" to be solved. Still, I like the idea of something a bit different, otherwise I'd have just bought a 172. |
#2
|
|||
|
|||
![]() BD5ER wrote: Sounds like a solution to a non-existent problem. Rich "To save an ounce, lose a hamburger" S. That weight reduction program is well underway. Hamburgers are in, just no carbs.......and the weight savings is already many times greater than all of the carbon and Spectra combined will save. I agree there isn't much of a "problem" to be solved. Still, I like the idea of something a bit different, otherwise I'd have just bought a 172. We use it in the skydiving industry for canopy lines. It appears to be very strong and abrasion resistant. The lines aren't much different in size than tooth picks. 500 or 800 pound test. The only problem is, it shrinks when heated. The line sets on our parachutes need to be replaced every so often because of abrasion heat. Usually around 500 jumps or so. Should not be a problem in most aircraft. Also, UV can hurt the strength of the line. Dave |
#3
|
|||
|
|||
![]()
"BD5ER" wrote in message
... That weight reduction program is well underway. Hamburgers are in, just no carbs.......and the weight savings is already many times greater than all of the carbon and Spectra combined will save. I agree there isn't much of a "problem" to be solved. Still, I like the idea of something a bit different, otherwise I'd have just bought a 172. You need some of that stuff that was featured in "Fountains of Paradise" by Arthur C. Clarke. Rich S. |
#4
|
|||
|
|||
![]()
"Rich S." wrote in message ...
"BD5ER" wrote in message ... I agree there isn't much of a "problem" to be solved. Still, I like the idea of something a bit different, otherwise I'd have just bought a 172. You need some of that stuff that was featured in "Fountains of Paradise" by Arthur C. Clarke. The space-elevator cable stuff? Welcome to the 21st century - it's not quite unobtanium anymore. It's available (or soon will be) at your local Nano Depot in the Buckytubes aisle. Carbon filaments made of stacks of rings of carbon atoms. Tensile strength that makes steel look like wet tissue. Now if you could only get it in lengths greater than .01 mm ... Corrie |
#5
|
|||
|
|||
![]()
"Corrie" wrote in message
om... The space-elevator cable stuff? Welcome to the 21st century - it's not quite unobtanium anymore. It's available (or soon will be) at your local Nano Depot in the Buckytubes aisle. Carbon filaments made of stacks of rings of carbon atoms. Tensile strength that makes steel look like wet tissue. Now if you could only get it in lengths greater than .01 mm ... Yeah - that's it. I'd like it at least 3-4" long for a cheese slicer. Rich S. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
The Little Wheel in Back | Veeduber | Home Built | 6 | September 8th 03 10:29 AM |