![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
when you did it, did you wait until manovering speed before pulling
all the way back? I'd worry, in the Mooney, if the pilot in command (he loves being called that) pulled back to the stops at cruise. If you kept your wits about you, I'd guess firm back until I think 130 knots, then to the aft limit in that airplane, would probably only break a gyro or two, and not the backbone of the airplane. I don't know if its gyros are rated for more than 60 degrees back or pitch. I think the numbers would work out that we'd be well above stall at the top still pulling positive gees, then a roll to upright, with altitude in the bank. Be fun to try it in a simulator, but my personal PIC would not do it in the airplane unless there was building in front of him. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
F-15C in a tight turn | Tom Callahan | Aviation Photos | 1 | April 16th 07 06:58 PM |
Question: Standard rate turns, constant rate turns, and airspeed | Robert Barker | Piloting | 5 | April 15th 07 04:47 PM |
Tight Screw Causes Sea King Crash | Shiver Me Timbers | Rotorcraft | 0 | August 30th 04 04:12 PM |
Fly tight for tight bomb patterns on the ground. | ArtKramr | Military Aviation | 120 | August 30th 04 08:42 AM |
Tight patterns? | Bob Martin | Piloting | 51 | January 26th 04 08:42 AM |