|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 25th 07, 12:45 PM
posted to rec.aviation.simulators
|
|||
|
|||
FSX with Pentium IV machine
I still have a Pentium IV 3.1 processor with 2 gigs of ram and a
Nvidia GT 8600 card Thinking of buyng FSX Would it run on this configuration Eventually next year will be ugrading to a dual core processor machine and better graphics Probably will have to put sliders down but I just want to start looking at FSX since I believe in a few years FS9 will be obsolite 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cnc machine work? | dlevy | Home Built | 6 | October 6th 06 07:55 PM |
| composite machine | [email protected] | Home Built | 1 | November 28th 05 07:33 PM |
| Gun, machine gun and/or cannon? | Ctenos | Military Aviation | 16 | September 24th 04 08:51 PM |
| Fess up! Simming...and the machine..... | Dr. Anthony J. Lomenzo | Simulators | 1 | November 28th 03 05:31 PM |
| An Affordable Homebrue 60 in DS machine | Grant | Soaring | 0 | August 8th 03 03:52 AM |
Hybrid Mode
