![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
"William Hung" wrote in message ... I have the POH for it, C150/2, but haven't really gotten into it yet. Unlike many here, I'm very new at this Steven. I don't have as much to contribute, but at the same time I like to be in the conversation if that's not too much to ask. Perhaps I should wait until I get my CFII, ATP, 747 rating or an astronauts license before I can join all you guys? lol You should wait until you've read the manual before operating the airplane. No laughter at all. |
|
#2
|
|||
|
|||
|
"Steven P. McNicoll" wrote in
: "William Hung" wrote in message .. . I have the POH for it, C150/2, but haven't really gotten into it yet. Unlike many here, I'm very new at this Steven. I don't have as much to contribute, but at the same time I like to be in the conversation if that's not too much to ask. Perhaps I should wait until I get my CFII, ATP, 747 rating or an astronauts license before I can join all you guys? lol You should wait until you've read the manual before operating the airplane. No laughter at all. I suggested that to an FAA inspector who jumped into our B4 and asked me what the Va was and he told me "Stop being a wiseass, sonny, and tell me what I want to know" Bertie |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carbon brakes | [email protected] | Piloting | 3 | August 19th 06 08:01 AM |
| Trailer brakes | Bert Willing | Soaring | 1 | October 31st 03 08:55 AM |
| Cobratrailer&brakes | Greg Arnold | Soaring | 5 | October 6th 03 04:14 PM |
| rotor brakes | Bill Chernoff | Rotorcraft | 5 | September 6th 03 12:14 AM |
| Easy ? On Brakes | Denis Winters | Simulators | 2 | September 4th 03 01:07 PM |