A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Piloting
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Wing De-Icing Question



 
 
Thread Tools Display Modes
  #1  
Old February 17th 09, 09:03 AM posted to rec.aviation.piloting
VOR-DME
external usenet poster
 
Posts: 54
Default Wing De-Icing Question

In article ,
says...


On Feb 17, 1:43*am, VOR-DME wrote:
In article

,
says...



Interesting, in that we tend to handfly the Mooney in IMC, using
autopilot only when we need a break if there's only one pilot on
board. It's a subjective thing I suppose, but hand flying does not
take a lot of effort en route (or most of the time, if truth be told)
and I'd not want to have to suddenly transition to hand flying in IMC
in the unlikely event the autopilot had a subtle failure.


Interesting. I do not share your point of view, but I respect it.
I not only hand-fly, in training, but I (like others) fly partial panel, to
simulate vacuum failure (conventional systems) or electrical failure (glass
systems). In "real" flight, I use everything available, freeing up the xx%

of
my brain that was used just maintaining heading and altitude to maintain a
higher-level vision of the progress of the flight. I believe this overall
vision is more important that the difficulty of transitioning to a degraded
control mode in the case of a system failure, partly because of the
unlikelihood of the latter.


There's more to our side of the story -- we like to hand fly! Our self
adminstered safety flights are a bit more challenging than those
administered by our cfi, esp w/r/t partial panel, instrument
failures, and unusual attitudes. I suspect the difference in safety
between our two methods would be hard to quantify. One of us could
type more loudly than the other, I suppose -- this is the usernet
after all. .


Sorry for the /null/ post!!
I like to hand fly too. Insisted on it in my IR training. NDB approaches IMC as
well. But I won't subject my passengers to increased risk just because I think
it's more challenging for myself. IS THAT CLEAR? I*S T*H*A*T C*L*E*A*R*?? :-)

  #2  
Old February 17th 09, 01:29 AM posted to rec.aviation.piloting
Bear Bottoms[_4_]
external usenet poster
 
Posts: 127
Default Wing De-Icing Question

On Tue, 17 Feb 2009 00:03:27 -0800, VOR-DME wrote:

Sorry for the /null/ post!!


Onlyh an AssClown..........

I like to hand fly too.


Hand fly or hand job, AssClown?

Insisted on it in my IR training. NDB approaches IMC as
well. But I won't subject my passengers to increased risk just because I think
it's more challenging for myself. IS THAT CLEAR? I*S T*H*A*T C*L*E*A*R*?? :-)


Crystal.

Are youh an AssClown?

A*S*S*C*L*O*W*N* ?

Do I **** in the woods?
--
Bear Bottoms
Private Attorney General
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Wing walk ply question. Mustardbuilder Home Built 20 January 28th 07 11:16 AM
Rotor-wing question D. Andrews Rotorcraft 8 October 2nd 05 12:43 PM
Folded wing tip question a425couple Naval Aviation 35 May 13th 05 12:40 AM
Spitfire Mk XIV Wing Question [email protected] Military Aviation 3 September 19th 03 10:54 AM
Discus Wing question John Galloway Soaring 6 August 23rd 03 08:52 AM


All times are GMT +1. The time now is 11:46 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.