|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
March 6th 09, 10:01 PM
posted to rec.aviation.soaring
|
|||
|
|||
AR3201 Harness?
P.S. On the subject of voltage drops: I'm using 16 - 18 gauge wire
throughout, except for a short run of about 2 feet (inside the panel/ pedestal) where I'm using some of the small-gauge "telephone style" wiring that comes standard with the SNAV and Tasman. I may bite the bullet and break out my RJ-11/RJ-45 crimper and fab up some tefzel wires for that, too... I just don't want to have to go through the hassle of mail-ordering more Tefzel for just these two short bits! (Don't know of any local places that might carry Tefzel) :-P 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| looking for Hooker harness | Al MacDonald | Home Built | 0 | July 12th 08 04:54 PM |
| Wanted: Becker AR3201 | Ira Blieden | Soaring | 0 | December 14th 06 07:28 PM |
| Looking for a Becker AR3201 | Ira Blieden | Soaring | 0 | December 8th 06 02:38 PM |
| S-H safety harness (V2C) | [email protected] | Soaring | 20 | April 28th 06 09:54 AM |
| Harness | Nolaminar | Restoration | 2 | December 25th 03 04:04 PM |
Threaded Mode