![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]() "Bob Kuykendall" wrote Yup. They also don't seem to understand that someone who builds an aircraft from a kit or from plans is under no obligation to register that aircraft as having the same type as the kit prototype aircraft. For example, many of the Schreder HP-series kit sailplanes have types such as "Drew Two" and "RS-1" and "MR-3" instead of "HP-18" or "HP-11" or "HP-14." So there are no doubt several CH-601XL aircraft to which the NTSB's narrowly-worded letter A-09-30 does not apply. Overall, I think that the NTSB, while perhaps meaning well, is being too heavy-handed in asking the FAA to take this action. I think that it would be far more constructive to work with Zenith and with builders groups to make them aware of the issues and possible mitigations. I think that it would be well within the FAA's purview to firmly decline the NTSB's demands. ************************* Jim wrote: I see both sides of it, but think it is high time that the NTSB made a real effort to get some changes made, and the top change is to make all of the owners aware of the problems, as they see them. As far as the flutter issue goes, the case was made that even planes that had proper tension on controll cables have had cases of catestrophic flutter. It should not be that hard to get a mass ballance engineered, such as a "C" shaped ballance that penetrates the wing ahead of the hinge point, and attaches to top and bottom of the aileron. ***************************** If they ground every CH-601XL, what else could or might they have taken action against? Adventurers with their horizontal stabilizer attachment issues? BD-5As with their marginal takeoff characteristics and flaky engines? Vari-Ezes (not Long-Ezes) with their somewhat marginal wing carrythrough strength and attachment plate corrosion issues? And that's just a few experimental airplanes, to say nothing about gliders or rotorcraft. In all of these cases the carnage has been kept to a dull roar by kit makers and builder communities who (usually) worked together to raise awareness of the issues and to mitigate them. ********************** Jim wrote: It could be said that the NTSB should have taken a more active stand in many of the cases you mentioned, and many more might be alive. It would be a fresh breeze to see action taken before more "blood rules" have to be written. If this is the case, it would be wrong to let more die, just because that is the way it has been done in the past. -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Panel urges Navy move some jet training -- perhaps to Kingsville | Otis Willie | Naval Aviation | 1 | September 10th 05 03:53 AM |
AOPA urges allowing cell phone use in general aviation | Eric Greenwell | Soaring | 7 | March 30th 05 08:44 PM |
Grounding of K-7 and K-10s in the UK. | Robertmudd1u | Soaring | 1 | May 28th 04 02:53 AM |
Rabbi Urges Pig Fat on Buses to Stop Bombers | Mike Marron | Military Aviation | 11 | February 20th 04 11:37 PM |