![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
On Sat, 16 May 2009 10:58:14 -0400, "Peter Dohm"
wrote: I have heard that the (so called) area rule has a considerable effect on drag at surprisingly low speeds. Presuming that is the case, the benefit of the smaller diameter engine might be trivial, except on a single seater or a tandem two seater, so you might also consider the Rotec radial. Peter rotec is not in consideration. my target is a light 40 hp engine for single seat aircraft. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Zero time Aero Vee / Monnett engine | [email protected] | Aviation Marketplace | 0 | November 30th 05 06:02 AM |