|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 9th 10, 04:34 AM
posted to rec.aviation.owning
|
|||
|
|||
overhaul my 0-200A
In article ,
exxpilot wrote: Going to over haul my 0-200A... why... cosmetically it looks dirty and ugly... any one have any ideas to prepare for paint glass bead blasticing as a option...engine has 1100 SMOh and should go another few hours to TBO -1800hrs for this type engine... Paint stripper and pressure washer for the crankcase, then 2-part epoxy primer and 2-part final coat of paint (gloss, of course.) Engine enamel is inferior to the 2-part stuff out there. It also works on the cylinders. -- Remove _'s from email address to talk to me. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Subaru flywheel pto shaft | [email protected] | Home Built | 5 | November 28th 05 12:05 AM |
| Auto. engine >> vertical shaft power output | [email protected] | Rotorcraft | 4 | June 2nd 05 07:16 PM |
| Throttle movement | Max Richter | Naval Aviation | 12 | December 11th 04 11:09 PM |
| Air Force issues ‘stop movement’ for Patrick, Cape Canaveral | Otis Willie | Military Aviation | 0 | September 25th 04 09:30 PM |
| Lubricating the primer shaft | Michael Horowitz | Home Built | 9 | November 20th 03 12:26 AM |
Hybrid Mode
