![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Sep 7, 11:19*pm, "F-U-Ed." wrote:
Just for your information, before you so blatantly post such rude and one sided statements, you should know that this pilot... [Full message and header omitted but on file.] Reading Cindy's post, and even between its lines, I really don't see any content that particularly defames the Puch. I'm guessing that most European sailplanes are susceptible to very similar failure modes. There is an excellent lesson here that a good PCC should also include the axial play of control surfaces, and not just their deflection, sense, and slop. Also, if you really must post material like this, my suggestion would be to do so either more completely anonymously or more openly. And better yet either more moderately or not at all. I think we've all occasionally posted in haste and repented at leisure, so I do understand how strong feelings can cloud one's judgment. Mike's suggestion of taking a deep breath before clicking Send is probably a good one. Thanks, Bob K. |
#2
|
|||
|
|||
![]() Reading Cindy's post, and even between its lines, I really don't see any content that particularly defames the Puch. Thanks. I'm sensitive about Pooches overall, and wanted to be as fair to the airframe as I could be. There is an excellent lesson here that a good PCC should also include the axial play of control surfaces, and not just their deflection, sense, and slop. THAT was/is the message the pilot and I wanted to emphasize. Thanks for the comment about AXIAL examination. I frequently see pilots wobble surfaces about, sometimes too roughly, and VERY seldom see someone check all surfaces for all three axes of movement. That could perhaps have found this as a potential departure of a surface. I was delighted to read the thread's progress tonight. Thank you to Eric M. for the detail and thoughtfullness of his contribution. And to JJ. I couldn't begin to recall the fanny hardware, as the last 50-3 I knew was over ten years ago, and only through one periodic inspection. (Tongue bit and lips clenched. Restraint shown here.) Thanks to many of you for defending my reputation! Ahhh, Chivalry. And Bob W. -- the incident report wasn't YET published. ;-) I wasn't waiting for Monday, as I only get to here intermittently. I am glad to see it recorded, and will be curious to see what, if any conclusions, can be drawn. I deliberately avoided any personal conjecture, writing only what was told to me. (Adjusting front pedals may have masked a 'moment of change', or not.) I did not point fingers of fault in any direction. There are plenty of US glider "events" that never make it into any reporting system. I only did what was asked -- to try to have some good results and discussions from an otherwise unsettling flight. I hope this inspires other pilots to POST and share things that keep each other more aware, more conscientious and still having fun with each other in 2011. We could all use the reminders. Cindy (who went wave soaring Wednesday) www.caracole-soaring.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Icing...some cautionary tales | Bob Gardner | Piloting | 0 | January 24th 08 10:04 PM |
Cautionary Tale: Logger Failures, Batteries, Backups, & GPS Altitude | Chip Bearden | Soaring | 9 | October 16th 07 04:44 PM |
Cautionary Tale: Logger Failures, Batteries, Backups, & GPS Altitude | Chip Bearden | Soaring | 2 | October 15th 07 07:18 PM |
Old timer tale | Frank Whiteley | Soaring | 2 | August 21st 06 05:28 PM |
FS: Blanik L-13 Tail Skid & Tail Wheel Assembly | Tim Hanke | Soaring | 0 | February 8th 05 01:34 PM |