![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Hello,
I'm buying a box hangar 60x80 about 15 years old. It's wood frame with metal siding and asphalt roof. Ceiling is also metal. Walls and ceiling are insulated, but the 55 foot wide bi-fold door is not. There is some air leakage around the door that I plan to fix. Rumor around the airport is that this hangar has a bad condensation problem in Spring and Fall. It's not heated and I hope to solve this problem without adding heat. It's located in Michigan. Could air circulation inside or perhaps outside to inside solve this issue? I'm told the Dew happens in the morning due to the building warming up before the concrete slab, which is still cold from the night before. They say the aircraft inside will form Dew on the airframe and even inside on the panel, Yikes! Heating the building is the easy answer and my last resort. Removing the insulation is not an option either. Thanks for helping! ~Bruce |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
condensation INSIDE of glider parts | Brad[_2_] | Soaring | 2 | January 12th 11 07:04 PM |
Condensation in hangar | karl gruber[_1_] | Owning | 7 | September 19th 07 03:48 PM |
t-hangar and ice | Bob Noel | Owning | 13 | October 19th 04 09:59 PM |
Hangar at FFZ | [email protected] | Aviation Marketplace | 1 | August 18th 04 09:40 PM |