![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Interesting, I took a couple of pictures of the hinge and they seem to show
no structural connection from the side rails to my cross member ? I am flying tomorrow so I will examine this further, but I wonder if they varied the construction. Many of my aluminium support brackets are glued to the shell with what looks like a black polyurethane glue, similar to that used in the car industry to glue panels. I assumed this was the case for this cross member. I agree that It would be ideal to change one bolt at a time, but I was thinking of implement Steve Koerners mod which I believe would require you to remove both bolts to get the 1/4" spacer under the handle ? It is riveted to the top side rails. However one US owner has found all rivets sheared. All mine seem ok. In any event you should only change one bolt at a time! Andy |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra Trailer Spare Tire mount failure | Barny | Soaring | 29 | July 23rd 15 12:52 AM |
Cobra bottle jack failure | db_sonic | Soaring | 15 | October 30th 09 03:34 PM |
cobra trailer brake lever gas strut failure? | Frank[_1_] | Soaring | 11 | March 31st 09 08:59 PM |
Hanger Queen meets Cobra - Cobra Girl 07.jpg (1/1) | Alan Erskine[_3_] | Aviation Photos | 9 | September 20th 08 04:35 PM |
Hanger Queen meets Cobra - Cobra Girl 05.jpg (1/1) | Glenn[_2_] | Aviation Photos | 0 | September 19th 08 03:41 PM |