|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 7th 11, 05:49 PM
posted to rec.aviation.soaring
|
|||
|
|||
Cambridge 302 USB Port
If you use a separate power source as you describe, how do you tie it into the serial cable?
|
|
#2
December 7th 11, 06:23 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Cambridge 302 USB Port
On Dec 7, 11:49*am, Karl Kunz wrote:
If you use a separate power source as you describe, how do you tie it into the serial cable? Serial communication doesn’t carry power over the same media as the communications. So Pins: 2 is RX and Pin 3 is TX. Pins 5 and 6 are 5VDC and Ground (if I remember correctly). Tim has the plug diagram on his web site. You can purchase a premade converter for the PDA, if you purchase the Oudie it already comes with a premade cable. Or you can make one yourselves
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cambridge data port pins | Andy[_1_] | Soaring | 4 | April 7th 08 06:11 AM |
| On the job with a port trucker: Port truckers like Marvin Palacios are the tiniest players in a prosperous global transport chain. But while big companies cash in, drivers barely make | Goteborgbank | Naval Aviation | 1 | October 13th 07 03:44 PM |
| On the job with a port trucker: Port truckers like Marvin Palacios are the tiniest players in a prosperous global transport chain. But while big companies cash in, drivers barely make | Goteborgbank | Piloting | 2 | October 2nd 07 11:12 PM |
| Port A Port hangar move | liteflyer 1 | Home Built | 0 | July 19th 06 06:46 AM |
| port a port t hangers? | liteflyer 1 | Home Built | 0 | May 25th 06 06:01 PM |
Hybrid Mode
