![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Whunicut" wrote in message ... What is the proper pressure to use with 5.00-5 mains and 10x3.50-4 nose for a 2250 gross canard plane? Another related question: both mains tend to loose air slowly - would be flat after about 3 months sitting. Is this typical or should I get new tubes? ------------------------------------------------- 1. Blow `em up until the sidewalls come off the ground. 2. Go to Home Depot and get some garden tractor/riding mower tubes. Use the old tubes for your rubber band gun. Warren, 59 years of dicking around planes. And bless you too. Why, Sir, that makes you the honored alpha male most beloved curmudgeon here. We got one who's been dickin' around for 50, so you got him beat. Besides, he don't seem to be building anything much nowadays like you are, just lobbing laurels on Lycoming and railing at the autoaero engine guys. Still kinda beloved though. Then we got the alpha female curmuffie, Syd the Snowbuzzard. She's currently discommoded by radio noise, but soon the agony will be abated once Weird gets it figgered out. |
#2
|
|||
|
|||
![]()
Why, Sir, that makes you the honored alpha male most
beloved curmudgeon here. We got one who's been dickin' around for 50, so you got him beat. Donno if thats something to be proud of or not. Time seems to speed up as you get older and birthdays come as an unwelcome surprise. If Ol Doc Plemmons passes my physical in a couple years, I`ll be close to Joining Gene W as an Octogenarian pilot. Scary. Warren, Look out below! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Manifold pressure gauge problem | Dave Russell | Aerobatics | 3 | January 29th 04 03:46 AM |
Nosewheel Shimmy and Scalloped Tire Redux, Plus | Larry Smith | Home Built | 2 | September 15th 03 04:03 PM |
Scalloped Nosewheel Tire | Larry Smith | Home Built | 7 | September 12th 03 09:16 PM |
Fuel pressure Problems | smf | Home Built | 3 | September 7th 03 08:25 PM |
Pressure Differential in heat Exchangers | Bruce A. Frank | Home Built | 4 | July 3rd 03 05:18 AM |