|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 8th 03, 02:40 AM
|
|||
|
|||
In article ,
Del Rawlins wrote: On 07 Nov 2003 04:03 PM, Neil Nelson posted the following: The most obvious trait to me is how easily the chrome plating chips/peels from the cheap brand tools (Craftsman, Matco, Mac), not what I'd want floating around inside the engine of the next airliner I get on. :-( We obviously aren't using the same Mac and Craftsman tools. Not unless you're sneaking into my shop when I'm not looking... Never used Matco so I can't say about them. As I posted earlier, my first experience with them was somewhat less than impressive. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RV-6 Snap Rolls | Ted Timmons | Aerobatics | 1 | February 2nd 05 10:48 PM |
| Snaps in the Decathlon | Dave Russell | Aerobatics | 12 | April 14th 04 06:14 PM |
| Snap roll vs. Va | Greg Esres | Aerobatics | 16 | December 2nd 03 11:14 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 03:07 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
Hybrid Mode
