Delcom Air 960 wiring

Was just about to do the same! haven't tried these but seen similar on
other sites:
http://www.delcom.com.hk/externalmicjack.html

Mike


At 21:06 17 January 2012, Bob Walker wrote:
Our club has a Delcom Air 960 panel mounted in a Schweizer 2-33.
Currently

we are using a speaker-mike which jacks into the front of the radio. We
would like to wire the radio with a speaker and two microphones. Does
anyone
know if this configuration is possible with this radio? If so, could you
provide a wiring diagram. Any help will be greatly appreciated.
Bob Walker

On Jan 18, 12:27*pm, Mike Gatfield wrote:
Was just about to do the same! haven't tried these but seen similar on
other sites:http://www.delcom.com.hk/externalmicjack.html

Mike

At 21:06 17 January 2012, Bob Walker wrote:



Our club has a Delcom Air 960 panel mounted in *a Schweizer 2-33.
Currently

we are using a speaker-mike which jacks into the front of the radio. We
would like to wire the radio with a speaker and two microphones. Does
anyone
know if this configuration is possible with this radio? If so, could you
provide a wiring diagram. Any help will be greatly appreciated.
Bob Walker- Hide quoted text -

- Show quoted text -

Use the quoted diagram and wire the two mikes parallel at the jack.
The PTTs and individual miles should be separate circuits and come
together at the jack.
when you key the mike that mike is "hot" and the transmitter is turned
on.
I had something like this for my old 2-22 radio.
I couldn't remember if the PTT was separate and went to the tip or
like shown. I bet for the drawing above.

JDB