![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
RST Engineering writes:
Varies with the engine, with the fuel atomizaion scheme, displacement, etc, but most of us live with a 15:1 air fuel ratio as a starting point. Jim By volume or by mass? -- Anyone who has two shirts when someone has none is not a Christian. ~ Lenny Bruce |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cessna 172 fuel selector | Ross | Owning | 12 | December 1st 08 05:44 PM |
Proper Torque for Fuel Fittings | Steve Waltner | Home Built | 10 | February 20th 05 12:46 AM |
Cessna 172 Fuel Flowmeter? | CVBreard | Piloting | 9 | January 26th 05 07:00 AM |
Proper yoke calibration | Rans | Simulators | 0 | December 1st 04 03:38 PM |
Proper stall recovery technique | Chris OCallaghan | Soaring | 0 | February 2nd 04 10:33 PM |