|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 10th 13, 10:27 PM
posted to rec.aviation.soaring
|
|||
|
|||
SN10b data to PNA?
On Sunday, November 10, 2013 12:14:03 PM UTC-5, wrote:
Looking for advice on how to send data from an ILEC SN10b to a pna device such as an Avier/Gliderguider etc. Thanks for any help. Mark Connect SN10 NMEA output (RS232) to PDA input. SN10 NMEA output is also connected for example to FLARM input for task declaration. Do **NOT** connect PDA output to SN10 !! Check SN10 option "PDA" to enable output. NOTE: PDA must use proper RS232 levels or you will have a small fire. Hope that helps, Best Regards, Dave "YO electric" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ILEC SN10B | [email protected] | Soaring | 5 | August 28th 13 11:55 PM |
| Looking for used SN10B | yankeegolf | Soaring | 0 | March 15th 10 01:21 PM |
| SN10B for sale | Dick[_3_] | Soaring | 0 | June 6th 09 10:05 PM |
| SeeYou Mobile with SN10B data | kirk.stant | Soaring | 30 | October 31st 08 09:01 PM |
| Digital airspace data question -- any FAA data gurus out there? | Tuno | Piloting | 2 | December 27th 07 06:06 PM |
Hybrid Mode
