![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I got some details from my trailer manufacture and supplier of the
flat-free wheel for the tail wheel from Blickle: 'The reference of the solid wheel is L-VWPP200G and it´s the same as used by HPH on the tail dollies of the Shark.' Please ignore the part of my earlier post about the tail dolly making towing back to the start more manoeuvrable. Of course all tail dollies caster the difference was noticeable because of the new bearings allowing the tail dolly to caster much more easily that the original dolly. Gavin Std Cirrus, G-SCNN, #173 SFV Südeifel, Utscheid, Germany |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tail dolly for 1-35? | [email protected] | Soaring | 5 | October 22nd 13 11:14 PM |
Glider Main Wheel Dolly | Jim[_18_] | Soaring | 0 | March 9th 11 04:19 PM |
2 wheel tail dolly towing system | Philippe Athuil | Soaring | 2 | June 1st 09 04:55 PM |
ASK-21 - is a tail dolly necessary? | Dave Springford | Soaring | 7 | December 31st 07 08:43 AM |
FS: Blanik L-13 Tail Skid & Tail Wheel Assembly | Tim Hanke | Soaring | 0 | February 8th 05 01:34 PM |