![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Believe those push-rod guides should be kept completely dry. I have seen ware at the guides caused by the push-rod banging around in the trailer. I know the LS-3a has this problem and it is best to tape the push-rod to the aft lift fitting before trailering (use the wing tape you just pulled off). Don't believe this applies to automatic control hook ups, unless you have an A model which have manual hook-ups on the ailerons.
Go Patriots!!!! JJ |
#2
|
|||
|
|||
![]()
Search "ventus aileron stiff" and find Dick Jonson's thoughts on the subject, he used 2 drops of WD-40 yearly in a hole he drilled to access the problem area. He also talked about sanding the aileron gap between wing skin and aileron...............all good stuff!
RIP Dick, JJ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Discus Aileron Seals | Peter F[_2_] | Soaring | 8 | August 20th 13 05:07 PM |
left aileron for Discus CS wanted | [email protected] | Soaring | 0 | September 28th 12 01:31 AM |
New Ventus 2 and Discus Winglets - M&H | Alpha Eight | Soaring | 11 | February 21st 12 04:41 PM |
Looking for Left Outer Aileron for Ventus C | Bob Gibbons[_2_] | Soaring | 0 | June 30th 09 02:12 AM |
Ventus 1 - anyone have experience w/o aileron centering spring? | Gary Emerson | Soaring | 0 | November 1st 08 02:36 PM |