|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 3rd 15, 07:24 PM
posted to rec.aviation.soaring
|
|||
|
|||
New Butterfly Display Software 3.2
On Tuesday, March 3, 2015 at 12:33:53 PM UTC-5, Ramy wrote:
The display may not be backlighted but it is as bright as needed and as easy to read as any other display in my cockpit. I have many hours of flying with the butterfly in panel display under any lighting conditions and never had an issue reading the display. I had issues early on with the external rectangular display due to polarization issue. There is definitely room for some improvement in the butterfly display in my wishlist, making it brighter is not one of them. Ramy You must have your butterfly display at the top of your panel. I don't have space there. Mine goes at far left (schleicher panel) and it is quite difficult to read there. The audio is more useful than anything else. Evan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flarm Butterfly display | [email protected] | Soaring | 10 | May 6th 13 05:40 PM |
| PowerFLARM core external display software update | kirk.stant | Soaring | 5 | January 28th 13 08:56 PM |
| Updating Software on Butterfly 57 mm version 2.1 display w/o Cable? | 3Y | Soaring | 7 | December 31st 12 12:50 PM |
| Butterfly external display questions | Andy[_1_] | Soaring | 30 | October 15th 12 07:20 AM |
| Question: Display symbology for wind vector in flight software | Tuno | Soaring | 2 | December 17th 09 04:14 PM |
Hybrid Mode
