|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 26th 15, 03:00 PM
posted to rec.aviation.soaring
|
|||
|
|||
Oxygen Mount Question
I have a Schempp-Hirth Oxygen mount that appears to use an "M" size
cylinder. 5.25 inches in diameter. Question: Steel or Aluminum? The front bracket that holds the cylinder neck, appears that it might fit steel cylinders only because of neck length, as it appears that aluminum cylinders have very little neck length. Does anyone know if the brackets Schempp-Hirth gliders ship with, will properly clamp around the aluminum cylinders? Thanks, Wells 9U --- This email has been checked for viruses by Avast antivirus software. http://www.avast.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blood Oxygen level question. | Udo | Soaring | 12 | January 27th 07 12:34 PM |
| Do you always have oxygen? | Mxsmanic | Piloting | 32 | November 18th 06 10:30 PM |
| Oxygen question | Dan Youngquist | Piloting | 8 | October 25th 06 04:26 PM |
| safety question: providing oxygen to a baby in the case of a drop of cabin pressure | [email protected] | General Aviation | 4 | August 27th 05 04:29 PM |
| Ram mount GPS | Hankal | Owning | 0 | October 23rd 03 03:34 PM |
Hybrid Mode
