|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 26th 15, 06:07 PM
posted to rec.aviation.soaring
|
|||
|
|||
PRESTEC (by Simtec)
On Friday, June 26, 2015 at 8:29:22 AM UTC-7, wrote:
On Friday, June 26, 2015 at 9:31:11 AM UTC-4, KEN wrote: Does anyone have any experience mixing Prestec with Duratec additive 904-001 to improve flow-out No experience with the additive. I did completely refinish my Std Cirrus this winter using Prestec. You can view the process at the Sid Cirrus Yahoo Group site. It is a folder titled 209 project. It turned out nice. Sprayed with conventional gravity feed gun. Added 30 percent acetone to aid flow out Lane No experience with the Duratec additive. In my experience, the best way to get it to flow out is to use a good quality slow flash lacquer thinner like Dupont 3602S. Use many thin coats to avoid sagging and overthin the last coat to help everything lay down. 
|
|
#2
June 26th 15, 09:13 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
PRESTEC (by Simtec)
Craig is right. I followed his advice when I painted my Tetra and it came out great.
Brad GK
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prestec Repairs? | Uniform Zulu[_2_] | Soaring | 1 | October 20th 08 09:42 PM |
| Prestec Repairs? | Uniform Zulu[_2_] | Soaring | 0 | October 20th 08 09:15 PM |
| Simtec/Prestec | [email protected] | Soaring | 2 | February 6th 07 08:46 PM |
Hybrid Mode
