|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 28th 16, 03:03 AM
posted to rec.aviation.soaring
|
|||
|
|||
Blanik screws?
On Sunday, March 27, 2016 at 8:00:05 AM UTC-7, Wade G wrote:
Ultimately what I likely will do is dimple to 90 degrees so for the non structural spots, I can use the ones at ACE hardware's "AN" section... I think the high cost from Blanik is because the screws are not made anymore. That might have been the cost to have them manufactured again. I have seven of those screws, contact me off-list with a mailing address and I'll get them in the mail. Thanks, Bob K. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blanik L -23 canopy screws | John Brennan[_2_] | Soaring | 3 | May 19th 11 02:49 AM |
| Blanik L-23 Super Blanik Manual -F.C.F.S. | Joel Flamenbaum | Soaring | 2 | April 14th 10 03:29 PM |
| TR-21 mounting screws | [email protected] | Soaring | 10 | March 26th 10 12:14 AM |
| FAA Screws Up Again | BushOKDemocratsSTUPID | Instrument Flight Rules | 2 | March 22nd 06 10:39 PM |
| Avsim screws itself | Azhosers | Simulators | 2 | April 5th 04 10:32 PM |
Hybrid Mode
