![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
There is an installation manual for the AR6201, available online, that has this information in detail (section 2-7). It's hard to give more specific advice because there are both wiring and software configuration options that interact and have to be set properly. In my motor glider this is ultimately controlled by a panel switch that specifies which mic is active. It seems to work well.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Motor Glider Becker Radio Set Up | 6X | Soaring | 0 | September 7th 16 11:08 PM |
Battery for Becker radio | HGXC[_2_] | Soaring | 4 | June 4th 14 12:06 AM |
Becker Radio Repair | Steve Leonard | Soaring | 2 | August 23rd 05 05:00 PM |
Becker radio repair | Steve Leonard | Soaring | 2 | August 23rd 05 02:25 AM |
Becker radio AD | Tom Serkowski | Soaring | 3 | November 2nd 04 01:43 AM |