![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]()
On Sunday, January 29, 2017 at 11:19:25 AM UTC-7, OHM Ω http://aviation.derosaweb.net wrote:
Diodes - @9B - Yep. Watch out for those lost volts. Regular 1N4xxx series diodes commonly used are even worse than Schottky! And you can also loose volts by using too small of wire (14ga for the main run), or too small of breakers. Breakers? Yes, breakers. Stick with 5A breakers or larger as even 4A breakers loose 0.3V and 1A breakers are awful loosing 1.1V (Klixon spec max voltage drop)!! Who knew? Most new setups use Lithium batteries these days. Lithiums do a very good job of holding voltage until the bitter end. That makes the forward drop from a Schottky combiner pretty insignificant. Agree about the low amp breakers though. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power Supply in 98 C182S | [email protected] | Piloting | 1 | April 23rd 07 09:55 AM |
Power Supply in 98 C182S | [email protected] | Owning | 1 | April 23rd 07 09:55 AM |
Power Supply in 98 C182S | Dan[_1_] | Piloting | 12 | April 16th 07 06:40 PM |
Power Supply in 98 C182S | Dan[_1_] | Owning | 12 | April 16th 07 06:40 PM |
WANTING GYRO POWER SUPPLY ???? | Tony | Home Built | 5 | March 7th 06 07:17 PM |