![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Saturday, April 13, 2019 at 11:33:40 AM UTC-7, wrote:
Going to try dual Craggy Aero 1/2 wave antennas on FLARM 1 and FLARM 2 mounted on both canopy rails just in front of the vent window. If you are running FLARM 1 and FLARM 2 antennae, where did you mounted the 3rd FLARM short diapole ADS-B antennae? I find many aftermarket 916MHz PowerFLARM antennae but no aftermarket PowerFLARM ADS-B antennae tuned to 1090MHz. Besides the stock PowerFLARM ADS-B dipole, are there other 1090MHz ADS-B antennae worth considering? How about it Richard @ Craggy Aero? I mount Flarm A on the top of the instrument panel and the Flarm B and ADS-B in the nose on opposite sides. Richard www.craggyaero.com |
#2
|
|||
|
|||
![]()
On Saturday, April 13, 2019 at 8:01:42 PM UTC-4, Richard Pfiffner wrote:
I mount Flarm A on the top of the instrument panel and the Flarm B and ADS-B in the nose on opposite sides. Richard www.craggyaero.com If your glider doesn't have metal or carbon fiber, seems like the big obstacle to the radio waves is the pilot's body. Would it make sense to mount one (FLARM) antenna in front of the pilot and the other (FLARM) one behind? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
VOR Antennae Installation | guynoir | Home Built | 1 | November 8th 06 03:37 AM |
FS Cambridge L-NAV and GPS-NAV combo | [email protected] | Soaring | 2 | October 15th 06 03:16 PM |
Pitot tube for the antennae | Ernest Christley | Home Built | 12 | May 29th 06 05:05 AM |
Which antennae please? | Robert Loer | Home Built | 1 | October 27th 04 11:55 PM |
WTB Looking for a used EGT/CHT combo | [email protected] | Aviation Marketplace | 0 | August 29th 04 08:16 PM |