|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 21st 19, 09:08 PM
posted to rec.aviation.soaring
|
|||
|
|||
LS3A flap/aileron mixer
Or with eccentric wing carry through pins, as a few ASW 19s required back in the late 1970s. They altered one wing's angle of incidence. Or maybe both.. They apparently brought the two wings more into alignment. I've never understood how the main spar pins still went in. I suppose the adjustment was very small and one wing was very slightly twisted. Anyone recall this?
Chip Bearden JB 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rolladen- Schneider LS3A flap seals- Do they really make any difference? | [email protected] | Soaring | 0 | April 8th 18 05:44 AM |
| Rolladen- Schneider LS3A flap seals- Do they really make anydifference? | Dan Marotta | Soaring | 0 | February 19th 18 04:39 PM |
| Rolladen- Schneider LS3A flap seals- Do they really make any difference? | [email protected] | Soaring | 9 | February 19th 18 01:50 AM |
| FA: M18B Dromader Flap & Aileron | BFC | Aviation Marketplace | 0 | September 24th 04 04:29 PM |
| Flap/aileron don't line up -- always a problem? | Ben Jackson | Owning | 4 | April 13th 04 01:53 AM |
Hybrid Mode
