If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
L3 (BFGoodrich) WX1000+ Stormscope wiring
"James M. Knox" wrote in message 2... That sounds like simply a bad connection... PROBABLY either in the ground or power circuit. Note that this might not be external to the unit - it could be an internal bad connection. I'd start by turning the thing on, on the ground with the engine off. Have one person watch the screen, while the smaller person crawls under the dash and starts thumping and tugging on the unit and on wires. It's a LOT easier if you can reproduce the problem on the ground!!! Thank you James. I already got a pvt responce from here with what I wanted. This is exactly what we intend to do but with the installation manual in hand ;-) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
L3 (BFGoodrich) WX1000+ Stormscope wiring | Kyprianos Biris[_2_] | Owning | 2 | October 8th 07 04:39 PM |
WX1000+ Stormscope problem | Kyprianos Biris[_2_] | Owning | 1 | August 7th 07 02:38 AM |
Stormscope | Roland | Instrument Flight Rules | 10 | December 4th 05 07:51 PM |
WX1000 Stormscope battery | D. J. Gooding | Owning | 2 | August 9th 03 02:25 AM |