If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Instrument tubing Y splitter
I used the Y fitting to get a better layout in the instrument panel, where T types tended to kink the tubes, before I changed to Silicon vacuum hose which is much better than the clear vinyl tube we usually use. Range of colours is good too, you can have each circuit a different colour. The Y pieces and tube came from auto suppliers on eBay(about $7 per meter). I ended up using 4mm ID as rather 5mm didn’t grip too well, no leaks but too easy to pull off. All works great now and the tubes can be unplugged easily for testing, without having to redo the ends every time.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Instrument tubing | soaringjac | Soaring | 15 | August 11th 19 05:46 PM |
Source of green donuts for instrument tubing installation? | Movses Babayan | Soaring | 14 | April 10th 18 09:45 PM |
Relesable instrument tubing | [email protected] | Soaring | 6 | February 13th 07 05:38 AM |
signal splitter | Tri-Pacer | Home Built | 2 | November 5th 05 09:47 PM |
source for clear+red instrument tubing | John W | Soaring | 8 | November 1st 04 01:19 PM |