|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 23rd 14, 03:12 PM
posted to rec.aviation.soaring
|
|||
|
|||
Nylon Sleeve in Rudder S-tube
Some time ago JJ had a good writeup on rudder pedals, S-tubes, rudder cables, etc. I'm in the process of replacing a rudder cable that has a bit of fraying. The nylon sleeves in both S-tubes are too far out the rear with no sleeve showing at the front. In addition, I suspect one nylon sleeve is damaged. Is there a simple, not too painful way to replace these sleeves?
Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wedekind sleeve | Hartley Falbaum[_2_] | Soaring | 4 | February 5th 14 12:54 PM |
| Need a tie-down sleeve (cuff?) for LS-4 | Uncle Fuzzy[_2_] | Soaring | 5 | August 23rd 13 11:03 PM |
| Followup -- Rudder Cable Sleeve | Michael J. | Soaring | 0 | June 24th 12 07:11 PM |
| Tie down sleeve for Ventus 2 | Steve Leonard | Soaring | 7 | April 5th 07 08:04 PM |
| Navman GPS sleeve | Oscar Goudriaan | Soaring | 1 | March 2nd 07 09:27 PM |
Threaded Mode