|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 19th 21, 07:51 PM
posted to rec.aviation.soaring
|
|||
|
|||
polyurethane finishes
The process details and products on this page
http://www.craggyaero.com/ventus.htm Held up extremely well on my wings done 20 years ago. The glider was out in the sun from April to Oct in Northern California and in a trailer outside all winter. No blister etc. The page above details the refinish of the fuselage, it was also done 20 years ago with PolyFiber waterborne polyurethane that did not hold up at all. The acrylic urethane used on the wings and the refinish of the fuselage was PPG JAU Direct Gloss Acrylic Urethane Shopline, 1/2 the price as the expensive stuff. Richard www.craggyaero.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sailplane Finishes | Buba Smith | Soaring | 7 | December 27th 11 03:40 PM |
| UK Contest Finishes | johngalloway[_2_] | Soaring | 1 | September 1st 11 02:28 AM |
| Polyurethane finish? | Uniform Zulu | Soaring | 5 | February 7th 08 07:32 AM |
| competition finishes | Derek Ruddock | Soaring | 7 | February 13th 07 01:00 PM |
| GP finishes | bagmaker | Soaring | 0 | May 25th 06 12:11 AM |
Hybrid Mode
