|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 20th 03, 09:15 PM
|
|||
|
|||
Rudder problems
I've just installed CH Pro rudder and pedals, gameport version, and can't
seem to get the rudder control to work correctly. In the calibration area the rudder and throttle are both assigned to the Z axis and I'm unable to change it. Shouldn't the rudder be assigned to the "R" axis? The yoke assignments work fine so now looking for help from someone who may have experienced and solved the same problem. Thanks for any help. Murphy 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air Bus 300 crash in NY now blamed on co-pilot's improper use of rudder | Corky Scott | Piloting | 30 | October 28th 04 04:10 AM |
| B2 Split Rudder | Emilio | Military Aviation | 8 | April 12th 04 10:43 AM |
| A lesson learned - Invisible rider with foot on right rudder | Dave Butler | Piloting | 2 | October 16th 03 09:58 PM |
| Cessna 150 Price Outlook | Charles Talleyrand | Owning | 80 | October 16th 03 02:18 PM |
| Rudder cable - was The Little Wheel in Back | BD5ER | Home Built | 9 | September 11th 03 04:14 PM |
Threaded Mode