If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
dimensional stability of composites
If you think the fuselage is being distorted, then adjust the trailer nose cone, down a tad. More likely the gap wasn’t correct when canopy was replaced. Should have 1/16” gap forward and aft with shop temperature 65f.
JJ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about spoilers and pitch stability | Larry Suter | Soaring | 50 | February 16th 13 12:14 AM |
Stability variation | WingFlaps | Piloting | 2 | April 28th 08 03:45 AM |
Towing stability studies | Dan G | Soaring | 27 | February 21st 08 08:38 PM |
Tow vehicle -- electronic stability control | Greg Arnold | Soaring | 4 | June 8th 06 12:31 PM |
Atmospheric stability and lapse rate | Andrew Sarangan | Piloting | 39 | February 11th 05 05:34 AM |