|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 31st 04, 12:32 AM
|
|||
|
|||
PINOUT NEEDED - ARC Transponder
I am replacing an old ARC with the new Narco Digital. Does anyone have the
pinout for the ARC RT 359A Transponder or where to find it? Thanks Barry 
|
|
#2
August 31st 04, 03:14 AM
|
|||
|
|||
|
log wrote:
I am replacing an old ARC with the new Narco Digital. Does anyone have the pinout for the ARC RT 359A Transponder or where to find it? Thanks Barry Barry, Here goes: pin 1 = Ground 2 Ground 3 Remote ident 4 (not used) 5 Remote ident (momentary, to #3) 6 (not used) 7 (not used) 8 Power jumper 9 Switched power out 10 D4 11 Mode C common 12 Lighting 13 A2 14 A1 15 A4 16 B4 17 B2 18 C2 19 B1 20 C4 21 C1 22 14/28 VDC input 23 Power jumper (direct to #8 for 14 VDC, with dropping resistor for 28VDC) Hope this helps. Happy Flying! Scott Skylane
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 04:29 PM |
| Fixing the Transponder with Duct Tape and Aluminum Foil | Ron Wanttaja | Home Built | 45 | March 14th 04 12:18 AM |
| WTB: Mode C Transponder | Chris Batcheller | Aviation Marketplace | 0 | February 21st 04 01:31 PM |
| Altimeter And Transponder Certifications - Dallas | Dave | Aviation Marketplace | 0 | September 20th 03 03:55 PM |
| transponder check? | Russell Duffy | Home Built | 10 | August 14th 03 11:36 PM |
Hybrid Mode
