![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Hello,
I've to replace the rubber seal between the wing and the fuselage. The problem is that I do not know what glue to use. My mechanic told me to use Bison Tix, this made me to rise an eyebrow because I was once being told not to use that stuff because of corrosion problems.(This was when I was serving our airforce, a very long time ago) Does anybody has a good glue tip? If possible one that works at temps slightly above freezing, I do not want to wait till spring. Thanks -Kees |
|
#2
|
|||
|
|||
|
Use 3M 1300L contact cement.
Mike MU-2 wrote in message oups.com... Hello, I've to replace the rubber seal between the wing and the fuselage. The problem is that I do not know what glue to use. My mechanic told me to use Bison Tix, this made me to rise an eyebrow because I was once being told not to use that stuff because of corrosion problems.(This was when I was serving our airforce, a very long time ago) Does anybody has a good glue tip? If possible one that works at temps slightly above freezing, I do not want to wait till spring. Thanks -Kees |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GPT (Gulfport MS) ILS 14 question | A Lieberman | Instrument Flight Rules | 18 | January 30th 05 05:51 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 06:03 AM |
| Phoenix AIM-54A (QUESTION) | Krztalizer | Naval Aviation | 10 | February 23rd 04 08:22 AM |
| Drywall Gussets | Veeduber | Home Built | 5 | October 27th 03 10:03 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |