![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
My Tail Dolly suffered being run over last week and was fairly well destroyed. Any one out there with a dolly for sale that would work for this ship?
Tom |
#2
|
|||
|
|||
![]()
On Thursday, July 7, 2016 at 2:40:09 PM UTC-5, Discus 44 wrote:
My Tail Dolly suffered being run over last week and was fairly well destroyed. Any one out there with a dolly for sale that would work for this ship? Tom how close would a pegase tail dolly be? I have one that looks new Scott W |
#3
|
|||
|
|||
![]()
Without changes, likely a bit big since the tail booms on ASW-19, ASW-20, Pegase a little larger than a ASW-24 or later. It could always be "futzed with" though.
|
#4
|
|||
|
|||
![]()
On Thursday, July 7, 2016 at 2:40:09 PM UTC-5, Discus 44 wrote:
My Tail Dolly suffered being run over last week and was fairly well destroyed. Any one out there with a dolly for sale that would work for this ship? Tom Well, This Pegasus tail dolly looks like a new one and I "d let it go for $250 And pay for shipping to the lower 48 States if anyone needs it, It's too Small for my std cirrus Thanks, Scott W 405-two 46-81two nine |
#5
|
|||
|
|||
![]()
On Friday, July 8, 2016 at 4:38:49 AM UTC+1, shkdriver wrote:
On Thursday, July 7, 2016 at 2:40:09 PM UTC-5, Discus 44 wrote: My Tail Dolly suffered being run over last week and was fairly well destroyed. Any one out there with a dolly for sale that would work for this ship? Tom Well, This Pegasus tail dolly looks like a new one and I "d let it go for $250 And pay for shipping to the lower 48 States if anyone needs it, It's too Small for my std cirrus Thanks, Scott W 405-two 46-81two nine Better to have no dolly than a wrong fitted one |
#6
|
|||
|
|||
![]()
Thanks, but I will pass on the Pegasus dolly. Might have to just repair the one I have. New one from factory is 325 Euro minus shipping and all that. If I have to I could order it.
|
#7
|
|||
|
|||
![]()
I have a tail dolly for a ASW27 I also have a match tow bar.
Barry |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ka-6 E Tail Dolly | [email protected] | Soaring | 0 | November 8th 15 04:26 PM |
Tail dolly for 1-35? | [email protected] | Soaring | 5 | October 22nd 13 11:14 PM |
LS4 tail dolly | Leigh | Soaring | 0 | May 30th 08 02:02 AM |
FS: ASW-24 Tail Dolly | [email protected] | Soaring | 0 | December 26th 06 02:40 PM |
WTB: used tail dolly | David Campbell | Soaring | 5 | April 17th 06 03:19 PM |