|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 22nd 05, 04:14 AM
|
|||
|
|||
Looking for 3/8 in-24 thread/low profile self locking nuts/
I need 2 low profile nuts as noted above for my lower engine mounts.
Can't seem to locate them anywhere. Aircraft Spruce does not carry them and they say they are only made for specific aircraft application. Any ideas where I can find them? Thanks. Larry/San Diego 
|
|
#2
February 22nd 05, 01:12 PM
|
|||
|
|||
|
Larry wrote:
I need 2 low profile nuts as noted above for my lower engine mounts. Can't seem to locate them anywhere. Aircraft Spruce does not carry them and they say they are only made for specific aircraft application. Any ideas where I can find them? Thanks. Larry/San Diego Larry: You are only going to find industry standard hardware. Go to McMasterCarr (they have their entire catalog on line). The posting w/ the nuts section also gives all the dimensions. -- FXS_at_beechhurst.com
|
|
#3
February 22nd 05, 02:59 PM
|
|||
|
|||
|
Try Marshall's on Production Ave...... turn left off Mira Mar Rd., cross rr
tracks, it's on your right. They have everything. "Larry" wrote in message oups.com... I need 2 low profile nuts as noted above for my lower engine mounts. Can't seem to locate them anywhere. Aircraft Spruce does not carry them and they say they are only made for specific aircraft application. Any ideas where I can find them? Thanks. Larry/San Diego
|
|
#4
February 22nd 05, 03:02 PM
|
|||
|
|||
|
I always turn left........ you might want to turn North.
"larsen-tools" wrote in message news:UOHSd.19196$Tt.17656@fed1read05... Try Marshall's on Production Ave...... turn left off Mira Mar Rd., cross rr tracks, it's on your right. They have everything. "Larry" wrote in message oups.com... I need 2 low profile nuts as noted above for my lower engine mounts. Can't seem to locate them anywhere. Aircraft Spruce does not carry them and they say they are only made for specific aircraft application. Any ideas where I can find them? Thanks. Larry/San Diego
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vapor Lock | Dale | General Aviation | 3 | August 8th 04 03:50 PM |
| One door | PaulaJay1 | Owning | 17 | January 1st 04 12:02 AM |
| Shakespeare Throttle Friction Lock | Larry Smith | Home Built | 3 | November 8th 03 03:01 PM |
Hybrid Mode
