GN II & Compaq Aero 1530

HI all
The buttons for scale menu, turn points and MC, will set off the
reset button. Only after I push reset can I push scale or any other button
again and after that it will work. this will repeat it self every time I
want a change. This is a very slow process.
Also once in the while the image of the 5 mile starting cylinder will
disappear after being airborne for sometime. All sua images are ok.
The numerical info is still present and working ok.
It tried to get some answers on the GNII Yahoo group or from Paul Remde. No
answers from him or the group.
Maybe someone has had a similar experience.
Please advise.
Udo

Hi Udo,

I did post a response to the group. Perhaps my response was sent after you
sent this note.

In my note I said I don't understand your note below - sorry. Please call
me to discuss this. What reset button is set off?

The start cylinder ring issue is a new one to me. I copied Chip on your
note.

Thanks,

Paul Remde


"Udo Rumpf" wrote in message
.. .
HI all
The buttons for scale menu, turn points and MC, will set off the
reset button. Only after I push reset can I push scale or any other button
again and after that it will work. this will repeat it self every time I
want a change. This is a very slow process.
Also once in the while the image of the 5 mile starting cylinder will
disappear after being airborne for sometime. All sua images are ok.
The numerical info is still present and working ok.
It tried to get some answers on the GNII Yahoo group or from Paul Remde.
No
answers from him or the group.
Maybe someone has had a similar experience.
Please advise.
Udo