|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 28th 20, 10:32 PM
posted to rec.aviation.soaring
|
|||
|
|||
Ventus C refinish, wing templates?
I am thinking about doing a refinish on my Ventus C.
I am wondering if wing templates are available? Also I'd like to cut down some of the cost by doing most of the grunt work myself. Under the watchful eye and coaching of a knowledable refinisher. Is there anyone I can go to who would could help with that. Obviously I would pay them for their time. At this point I am just trying to think over some options. Mike 
|
|
#2
July 29th 20, 01:47 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
Ventus C refinish, wing templates?
Where are you located? That will determine who you might be able to work with.
Mike
|
|
#3
July 29th 20, 03:04 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
Ventus C refinish, wing templates?
I reside in Florida.
So south east coast. I also spend a few months in Utah every summer bringing my glider with me. I could extend that travel time.
|
|
#4
July 29th 20, 04:32 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
Ventus C refinish, wing templates?
Mike,
Look up John Neel on the SSA member locator. He lives in UT and has done a lot of rebuild/refinish work. He may be willing to have you do the "grunt" work with his supervision. Mike
|
|
#5
July 29th 20, 06:18 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Ventus C refinish, wing templates?
On Tuesday, July 28, 2020 at 9:32:56 PM UTC-6, SoaringXCellence wrote:
Mike, Look up John Neel on the SSA member locator. He lives in UT and has done a lot of rebuild/refinish work. He may be willing to have you do the "grunt" work with his supervision. Mike Thanks, will do!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LS-3 Wing Profile Templates | Dan Marotta | Soaring | 2 | November 11th 11 03:50 PM |
| So do Boeing 787's need wing sand, wax, buff, reprofile, refinish? | Stewart Kissel | Soaring | 20 | July 18th 07 07:07 AM |
| ASG-29/ASW-27 wing refinish | [email protected] | Soaring | 23 | November 14th 06 11:28 PM |
| Nimbus 2c wing templates | Robert Hart | Soaring | 7 | March 3rd 06 05:25 PM |
| ASW27 wing profile templates | basils27 | Soaring | 0 | June 29th 05 11:46 AM |
Hybrid Mode
