|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 22nd 05, 08:09 PM
|
|||
|
|||
O200 nose
Hello,
On an O200 nose, we can see four threaded holes 1/4-20. I have a bad copy of the drawing I read 1-7/8 from center line horizontaly and 1-5/8 from center line verticaly. Is it true? I can't read the pilot diameter? Is someone knows it? Thanks for the answers. -- Pub: http://www.slowfood.fr/france Philippe Vessaire Ò¿Ó¬ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Twin nose protection | Jim Burns | Owning | 5 | January 4th 05 07:18 PM |
| Three more newbie Qs, if you don't mind :) | Ramapriya | Piloting | 17 | November 7th 04 05:03 AM |
| Piper 6.00x6 Nose Wheel and Fork? | mikem | Products | 5 | March 5th 04 11:34 PM |
| VW-1 C-121J landing with unlocked nose wheel | Mel Davidow LT USNR Ret | Military Aviation | 1 | January 19th 04 05:22 AM |
| Rolling a 172 - or not | Scott Lowrey | Piloting | 55 | November 16th 03 12:15 AM |
Hybrid Mode
