![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
A CFI I had lunch with last week suggested I should always do full stop taxi
backs instead of touch and goes when practicing landings. I've frequently done touch and goes for about an hour when I wanted to do some quick flying, but I tried his suggestion. I also ran into an old AOPA Flight Training magazine that had an article suggesting full stop taxi backs instead of touch and goes. I generally keep the pattern in tight and can do ten touch and goes in about .8 or .9 Hobbs depending on the amount of other traffic. I prefer towered airports for this practice, because there is another set of eyes looking for aircraft. Should I force myself to always do full stop taxi backs, even thought other pilots and tower personnel seem to prefer that I do touch and goes? Kevin Dunlevy |
#2
|
|||
|
|||
![]()
I always have my students do full stop. Things can happen very, very
fast and any problem with the aircraft or enviroment (winds, etc) are just a bit harder to manage during a touch and go. I teach at one airport with a 4K foot runway and I require my students to taxi back. I teach at another with a 12,000 foot runway and I allow them to stop and go on the runway. BTW: I could pretty much guarantee you that the tower couldn't care less. -Robert, CFI |
#4
|
|||
|
|||
![]()
On 2005-09-12, Kevin Dunlevy wrote:
Should I force myself to always do full stop taxi backs, even thought other pilots and tower personnel seem to prefer that I do touch and goes? Kevin Dunlevy Depends on how bad you need taxi practice ![]() More seriously, if you feel rushed by the touch & go's then the taxi back can give you time to settle down. In the Pitts I do touch & go's but I make sure to slow down enough to brush up on slow speed control before powering back up. |
#5
|
|||
|
|||
![]()
In a training context, I would rather taxi back myself while discussing the
just-completed landing with the student. After certification, I have nothing against T&Gs except for the concerns about trying to do too many things at once. That is a personal decision that has to be made by each individual based on his or her assessment of proficiency. Number of landings per hour is a meaningless figure. Bob Gardner "Kevin Dunlevy" wrote in message ... A CFI I had lunch with last week suggested I should always do full stop taxi backs instead of touch and goes when practicing landings. I've frequently done touch and goes for about an hour when I wanted to do some quick flying, but I tried his suggestion. I also ran into an old AOPA Flight Training magazine that had an article suggesting full stop taxi backs instead of touch and goes. I generally keep the pattern in tight and can do ten touch and goes in about .8 or .9 Hobbs depending on the amount of other traffic. I prefer towered airports for this practice, because there is another set of eyes looking for aircraft. Should I force myself to always do full stop taxi backs, even thought other pilots and tower personnel seem to prefer that I do touch and goes? Kevin Dunlevy |
#6
|
|||
|
|||
![]()
Kevin Dunlevy wrote:
A CFI I had lunch with last week suggested I should always do full stop taxi backs instead of touch and goes when practicing landings. I've frequently done touch and goes for about an hour when I wanted to do some quick flying, but I tried his suggestion. I also ran into an old AOPA Flight Training magazine that had an article suggesting full stop taxi backs instead of touch and goes. I generally keep the pattern in tight and can do ten touch and goes in about .8 or .9 Hobbs depending on the amount of other traffic. I prefer towered airports for this practice, because there is another set of eyes looking for aircraft. Should I force myself to always do full stop taxi backs, even thought other pilots and tower personnel seem to prefer that I do touch and goes? Kevin Dunlevy No. I'm curious though, what is the rationale given for avoiding T&Gs? Matt |
#7
|
|||
|
|||
![]()
Depends upon how long the runway is.
|
#8
|
|||
|
|||
![]()
A surprisingly large number of landing accidents are loss of control
after the airplane slows to about 30knots or so (often lower), which makes a lot of sense when you think about it. Your land based airplane has two basic modes of operation: tricycle (forwards or backwards) and airplane. When you're flying, it's 100% airplane, and when you're stopped, it's 100% tricycle. In between, you get varying ratios between the two. Because of this, as the airplane slows down (well below stall speed) you'll get into areas where aircraft control is a little different. Doing a full stop landing allows you to practice in this arena, but during most T&G's, the airplane never get's that slow. The other side is the safety related to reconfiguring the airplane on the roll. If you're taking your eyes and concentration away from what you're doing (flying/rolling out) bad things can happen quickly. Just my two cents. -Rob www.scarylittleairplanes.org |
#9
|
|||
|
|||
![]() No. I'm curious though, what is the rationale given for avoiding T&Gs? They are more dangerous than full stops - some flying schools have had to stop them as a condition of insurance. They don't give the instructor undivided attention while he critiques the landing. They don't allow the student to practice different types of takeoff. What do they actually achieve other than more landings per hour? And what does that mean if you are not practicing takeoffs? OK - my 2c Tony -- Tony Roberts PP-ASEL VFR OTT Night Cessna 172H C-GICE |
#10
|
|||
|
|||
![]()
If I'm in a bonanza, I'll do full stop, as there are a lot of things
you have to do (gear, etc), plus the hobbs only runs when weight is not on the gear. So taxi time is free, so why not? You get to log that time. If I'm in a Charokee, I'll do mainly T&G unless traffic or runway legnth becomes a factor. In a simple airplane, all you need to do is pretty much retract flaps. |
Thread Tools | |
Display Modes | |
|
|