|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 13th 06, 02:33 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Ultra Pup CG
Can anyone tell me what a typical cg location is for a typical ultra
pup (from the leading edge of the airfoil)? 
|
|
#2
July 14th 06, 10:59 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Ultra Pup CG
majduncan wrote: Can anyone tell me what a typical cg location is for a typical ultra pup (from the leading edge of the airfoil)? Try 24 to 26 percent of the wing cord, should be safe. IIRC that is a clark Y airfoil or something very close to it. For instance, if the wing measures 4 feet front to back, measure 12 to 13 inches back from LE. (I am assuming this is the "Hershey Bar" wing) Have you tried contacting the kit Mfg.? Or other builders? Hope this helps.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Don't click if you're not ultra rich | [email protected] | Instrument Flight Rules | 0 | June 27th 05 02:20 PM |
| Don't click if you're not ultra rich | [email protected] | Piloting | 8 | June 24th 05 05:55 AM |
| Don't click if you're not ultra rich | [email protected] | Owning | 5 | June 21st 05 09:35 PM |
| Preceptor Ultra Pup | Terry Smith | Home Built | 0 | May 13th 04 09:18 AM |
| FS: Pilot Aviation Ultra S-51 Headsets | Slor | Aviation Marketplace | 0 | November 25th 03 04:31 AM |
Hybrid Mode
