|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 31st 06, 02:33 AM
posted to rec.aviation.piloting,rec.aviation.owning
|
|||
|
|||
Injector insert for IO-360 engine
I seem to have lost the insert for one of the injectors on my IO-360
engine. Can anyone recommend a source to buy these? I've heard from some shops that I may need to buy an entire new injector but I thought I'd ask around if anyone knows another source. What do people do with the inserts when they replace injectors? -Robert 
|
|
#2
January 2nd 07, 01:03 PM
posted to rec.aviation.piloting,rec.aviation.owning
|
|||
|
|||
|
Injector insert for IO-360 engine
Robert M. Gary wrote: I seem to have lost the insert for one of the injectors on my IO-360 engine. Can anyone recommend a source to buy these? I've heard from some shops that I may need to buy an entire new injector but I thought I'd ask around if anyone knows another source. What do people do with the inserts when they replace injectors? -Robert I am not certain but I think that the insert is the injector. It is the insert that has the calibrated orifice. The threaded portion is just the carrier for that insert. I think that the two piece design is easier to make. You'll probably have to bite the bullet and buy the assembly. John Dupre'
|
|
#3
January 2nd 07, 10:20 PM
posted to rec.aviation.piloting,rec.aviation.owning
|
|||
|
|||
|
Injector insert for IO-360 engine
John wrote: Robert M. Gary wrote: I seem to have lost the insert for one of the injectors on my IO-360 engine. Can anyone recommend a source to buy these? I've heard from some shops that I may need to buy an entire new injector but I thought I'd ask around if anyone knows another source. What do people do with the inserts when they replace injectors? -Robert I am not certain but I think that the insert is the injector. It is the insert that has the calibrated orifice. The threaded portion is just the carrier for that insert. I think that the two piece design is easier to make. You'll probably have to bite the bullet and buy the assembly. This is a stock injector so they are all calibrated the same coming off the factory. No tuning to the application at all. -Robert
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air Force One Had to Intercept Some Inadvertent Flyers / How? | Rick Umali | Piloting | 29 | February 15th 06 04:40 AM |
| Engine Balancing and Resonance Vibration Problem | AllanFuller | Owning | 13 | September 12th 05 12:51 AM |
| Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 06:42 PM |
| What if the germans... | Charles Gray | Military Aviation | 119 | January 26th 04 11:20 PM |
| Real stats on engine failures? | Captain Wubba | Piloting | 127 | December 8th 03 04:09 PM |
Hybrid Mode
