|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 15th 15, 09:31 AM
posted to rec.aviation.soaring
|
|||
|
|||
CN1 Locking up
I noticed in a recent post by 2NO that his ClearNav 1 had "locked up" a few times.
I have had a number of episodes where the display is running perfectly but will not respond to any inputs from the hand-held controller (cannot change scale, wind, ballast, turn point, or any of the other "ribbon" variables). Sometimes this clears up with a re-boot; sometimes not. Unit recently went back to Gary Kammerer for service, but he was unable to ascertain the cause (no loose connections/cable faults). Any one else have this occur, or have any solutions? Bill 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Astir Locking Collars | Astir . | Soaring | 4 | August 26th 13 11:20 AM |
| LS1 Tail locking spring | Andrew[_9_] | Soaring | 7 | September 24th 10 03:09 AM |
| 90 degree locking pliers? | B. Jensen | Home Built | 8 | October 3rd 05 07:50 PM |
| New Wheel Locking Device | TM | Products | 2 | March 29th 05 05:07 PM |
| Looking for 3/8 in-24 thread/low profile self locking nuts/ | Larry | Home Built | 3 | February 22nd 05 04:02 PM |
Threaded Mode