|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 2nd 15, 06:37 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFLARM antenna separation
I just looked at the latest PF manual and it recommends 5 ft of separation between the PF A (xmit/rec) and B (rec only) flarm antennas. The older antenna installation documentation stated that a minimum of 1 ft was needed.
What gives? I have the A and B flarm antennas just over a foot apart in the nose of my LS6, wondering if I need to rethink the setup. Havn't any flight with other PFs around to use the range estimating tool. My earlier install had the A antenna in the nose cone and the B about 3 ft away on the side of the instrument panel cluster, and it had pretty good numbers for range and coverage. Kirk 66 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM antenna mounts | Dave Nadler | Soaring | 52 | August 14th 14 01:34 PM |
| PowerFlarm antenna recommendation | Sam Discusflyer[_2_] | Soaring | 3 | April 7th 13 08:41 PM |
| PowerFLARM Brick ADS-B antenna source? | Paul Remde | Soaring | 14 | October 16th 12 05:35 PM |
| PowerFLARM antenna mounts | Dave Nadler | Soaring | 0 | July 4th 12 04:11 PM |
| PowerFlarm antenna install | Sam Zimmerman | Soaring | 10 | November 11th 10 09:54 PM |
Threaded Mode