![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() steve mew wrote: I am an electronics engineer and I though a good project would be to build an aircraft tranceiver. Has anyone got any good schematics or ideas ? Since you want to build a transmitter on the aviation band, you have to meet some pretty tight bandwidth requirements. The last thing the aviation community needs is a unlicensed, possibly "dirty" transmitter on the aviation band. |
#2
|
|||
|
|||
![]()
I am an electronics engineer and I though a good project would be to build
an aircraft tranceiver. You may not operate such a tranciever (even to test it) unless you and the equipment are licensed. You won't get the equipment licensed without paying mucho money. Amateur ("ham") radio operator can build and operate their own equipment but only on the ham bands. That would be something to look into. Go to http://www.arrl.com for information on how to get involved in ham radio and get licensed. Jose -- (for Email, make the obvious changes in my address) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
King KX 155 Cct Diagram | Pete | Home Built | 0 | November 23rd 04 09:19 AM |
Premade master and circuit breaker panel | Corky Scott | Home Built | 6 | March 19th 04 02:18 PM |
OK, all you limeys: 4 beautiful chromium-plated valve covers for Continental O-200 | jls | Home Built | 5 | February 10th 04 05:36 PM |
FS on EBAY, circuit breaker switches | flyer | Home Built | 0 | December 3rd 03 06:59 PM |
Kawasaki TA-440 2B wiring diagram. | jackthepilot | Home Built | 1 | August 4th 03 06:33 PM |