|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 18th 04, 11:56 AM
|
|||
|
|||
The 10 mile circle isn't protected airspace. It means that the features
within in are drawn to scale. Iain "Stan Prevost" wrote in message ... On the procedure track and in the PT area, within the 10 nm circle, there is protected airspace at 4000. I don't know what is outside that. If he was getting VTF, he should have been given an altitude restriction until established, but he didn't tell us that part. Roy answered the full procedure case. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question on Airworthiness Inspection | Dave S | Home Built | 1 | August 10th 04 06:07 AM |
| Question: DP altitude vs MCA/MEA | Doug Easton | Instrument Flight Rules | 7 | April 7th 04 04:29 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 10:10 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 02:51 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |
Hybrid Mode
